everklear wrote:I think the newest NOOBS addresses this. I think.
Yes - basically it needs newer drivers for <INSERT OS HERE>, and the newest NOOBS has those. But things aren't quite that straightforward...
Given an existing, non-NOOBS, Raspbian install, the simple answer is to upgrade the OS by the usual 'apt-get upgrade' approach. Except you can't do that on the B+ itself, because there's no ethernet connection until the drivers are updated. As the underlying problem is in the USB driver, the USB ports aren't working either, so you can't just plug in a wifi dongle or other USB ethernet adaptor.
Possible solutions (I only tried the first):
* Update on an older model Pi then move the card across.
* Use a Serial connection to the UART pins on the GPIO, calling on all your powers of ancient Linux serial line stuff to somehow get a network connection running via SLIP/PPP.
* Create a nice new SD card, boot from that to get working USB, mount the old card via a USB adaptor, chroot into the old environment and run the update.
* Give up, reformat the card, and start again.
With a NOOBS installation things should be simpler - drop the new NOOBs files over the old ones, boot to the NOOBS UI and reinstall from there (assuming all the data you want to keep are on the separate data partition that you can optionally create with NOOBS). Unfortunately I've found that my older NOOBS created disk has set itself up with a 1.4GB RECOVERY partition, but the latest set of files comes to 1.5GB in size. So now I have some GParted work to do, if I don't want to reformat the card.
All this is only an issue if you try to use an older installation on a B+ without updating it first on an older Pi. But I think they should have made it clearer in their announcements that this could occur - they were so busy selling it as "it's not really a new model" that they failed to mention that the USB chip actually is.