Car servicing - are you sitting down?

Inane baanter or words of wisdom - you decide...
Post Reply
User avatar
Viscount Charles
Baaaaaa!
Baaaaaa!
Posts: 2008
Joined: Tue Sep 17, 2002 5:34 pm 0

Post by Viscount Charles »

I feel you pain. My first set of rear brake discs lasted just 20,000 miles, under a year - cost about £500 to replace, no question about it being done under warranty, "wear and tear item, sir, pay up."

Yet my CURRENT pads (which I EXPECT to wear) AND discs have together done something like 30-40,000 (I keep expecting them to tell me the pads need doing, they keep telling me that they're fine). So let me get this right - a set of pads on the front wheels have lasted longer than my first set of rear discs? And I've now done 100,000 miles, and the rear didcs haven't been replaced after that first time - still just wear and tear? Hmph.
"Put me back on my bike!"
User avatar
Dio
Sheepie Whore
Sheepie Whore
Posts: 18887
Joined: Mon May 31, 2004 1:08 pm 0
Location: Newcastle UK

Post by Dio »

I'd question the clutch going as non-warranty as well; a clutch should not fail inside five years unless there's a mechanical fault or your driving's seriously shafted.

Brake pads are a bit different - different types do have quite radically different wear patterns. The discs going early I would question though.
User avatar
Nerdsville
Baaaaa!
Baaaaa!
Posts: 1423
Joined: Mon Jun 16, 2003 11:07 am 0
Yahoo Messenger: nerdsville
Location: Nottinghamshire
Contact:

Post by Nerdsville »

Dio wrote:Brake pads are a bit different - different types do have quite radically different wear patterns. The discs going early I would question though.
I used a Nissan main dealer in Lincoln who at 70,000 miles told me my front discs on my XTrail were getting worn, asked if I need to replace them said "Oh no should be fine till next service but we will make a note so when you book your next service we will have them in stock..."

This main dealer goes into receivership so at the 82,000 mile service I had to take it to another main dealer in Grantham and mentioned about the discs, they took a look at them and said they were absolutely fine but I was in need of some new pads that should really have been replaced at last service! :?
InsanityWorks
"Do you ever get... Deja Vu?"
"No, but we get most of the other Sky channels."
User avatar
Kelloggs
Baaaaa!
Baaaaa!
Posts: 1859
Joined: Wed Jun 22, 2005 11:38 pm 0
XBL Gamertag: TheAntiKelloggs
Location: Widnes or Altrincham. Take your pick.

Post by Kelloggs »

(Note: This is what happens when I go to bed. Everyone wakes up while I'm asleep!)

The clutch on the last car was slipping, which I've experienced before. I could still drive it, but it was too far gone for others to. The only problem with this time was that selecting reverse (and only when it hadn't been run, and only in our drive) would *GRIND* four times out of five.

As an experiment, I tried backing into the drive, so the car would be parked the opposite way on the slight incline. Result: No grind. Only did that once, though, so I wouldn't treat it as statistically significant, but that sounds more like lubricant shifting under gravity to me.

I don't think it's my driving, but this is now the third bit of clutchwork needed in seventeen years' driving. I'm of the mind that - despite Ford's best protestations - such a major subsystem shouldn't be developing a fault quite so soon, unless I'm doing something so daft with the car as to leave evidence elsewhere.

However, I may have a secret weapon. My dad. Imagine, if you will, a Victor Meldrew-esque character who has, as one of his (few!) hobbies in life, writing extremely polite letters to high-ups in large companies, pointing out that the behaviour of their peons might not quite be commenurate with the image of the company that he's sure they would want to give. He and my mum are on holiday at the moment (hence why I am, too - I'm just Enjoying the Silence, to paraphrase Depeche Mode) and by my calculations, he'll have a good head of steam when he gets back next Tuesday to come up with something scathing.

While I'm off to Costco for new tyres, I might get a large tub of popcorn...
User avatar
kalmar
Baaaaaaa!
Baaaaaaa!
Posts: 8293
Joined: Fri Jun 24, 2005 2:46 pm 0
Location: Fife

Post by kalmar »

If it grinds when you try to select reverse (or is stiff to select 1st) it means that the gearbox shafts are turning. They basically shouldn't be when you've got the clutch fully pressed and the car is stationary.

I'd definitely go back and ask exactly what they did to fix it, what parts they changed etc.
(just show, no stabby stabby)
User avatar
Kelloggs
Baaaaa!
Baaaaa!
Posts: 1859
Joined: Wed Jun 22, 2005 11:38 pm 0
XBL Gamertag: TheAntiKelloggs
Location: Widnes or Altrincham. Take your pick.

Post by Kelloggs »

The itemised bill I have contains such lines as:

Code: Select all

KIT - CLUTCH RE                             95.15
:
:
SUPPLY AND FIT NEW CLUTCH                  315.00
(all ex. VAT, which then goes at the end). That's the only mention of Clutch in it.

When I brought the car home last night, reverse was silent; I'm out shopping today (for petrol, if nothing else) and I'll be listening very carefully for grinding noises.
User avatar
moosedude
Baaaaaaa!
Baaaaaaa!
Posts: 6209
Joined: Fri Nov 19, 2004 1:19 pm 0
Location: Craggy Island
Contact:

Post by moosedude »

Nerdsville wrote:
Dio wrote:Brake pads are a bit different - different types do have quite radically different wear patterns. The discs going early I would question though.
I used a Nissan main dealer in Lincoln who at 70,000 miles told me my front discs on my XTrail were getting worn, asked if I need to replace them said "Oh no should be fine till next service but we will make a note so when you book your next service we will have them in stock..."

This main dealer goes into receivership so at the 82,000 mile service I had to take it to another main dealer in Grantham and mentioned about the discs, they took a look at them and said they were absolutely fine but I was in need of some new pads that should really have been replaced at last service! :?
Flipping Heck! I would of swallowed my own tounge hearing that. Don't replace the pads and they'll damage the discs eventually, and then they get to sell you disc/pad combo next service, cheeky sob's.

01000101 01000100 01000111 01000101

http://www.redbubble.com/people/fotofill/ buy my photos!
User avatar
Dio
Sheepie Whore
Sheepie Whore
Posts: 18887
Joined: Mon May 31, 2004 1:08 pm 0
Location: Newcastle UK

Post by Dio »

Kelloggs wrote:I don't think it's my driving, but this is now the third bit of clutchwork needed in seventeen years' driving.
Hmmm. If those have mostly been old motors (5 years plus) that's nothing to worry about. If they've been significantly newer than that, I would say that's an odd statistical blip - but could still be within the grounds of random chance, particularly if you live in a hilly area...

Don't remember ever having had a clutch change myself, although I've had cable problems (but that car was best part of 15 years old at that point :D ).
User avatar
kalmar
Baaaaaaa!
Baaaaaaa!
Posts: 8293
Joined: Fri Jun 24, 2005 2:46 pm 0
Location: Fife

Post by kalmar »

Kelloggs wrote:The itemised bill I have contains such lines as:

Code: Select all

KIT - CLUTCH RE                             95.15
:
:
SUPPLY AND FIT NEW CLUTCH                  315.00
(all ex. VAT, which then goes at the end). That's the only mention of Clutch in it.

When I brought the car home last night, reverse was silent; I'm out shopping today (for petrol, if nothing else) and I'll be listening very carefully for grinding noises.
Weird. Suppose a warped clutch disc could have caused it but that's pretty rare. You haven't been towing heavy things with it or anything like that?
(just show, no stabby stabby)
User avatar
Kelloggs
Baaaaa!
Baaaaa!
Posts: 1859
Joined: Wed Jun 22, 2005 11:38 pm 0
XBL Gamertag: TheAntiKelloggs
Location: Widnes or Altrincham. Take your pick.

Post by Kelloggs »

--> Dio: I should clarify that. Last car was sold with a (six-month old) replacement clutch in it, after it slipping to buggery. Car before that was sold with the clutch slipping (back to the dealership. Tee hee!)

This, however, is the only car with this particular (grinding on reverse selection) problem.

--> kalmar: No towball. The only heavy thing that's been anywhere near this car is me.
User avatar
Mayhem
Sheepie Whore
Sheepie Whore
Posts: 12572
Joined: Mon Apr 29, 2002 3:06 pm 0
Location: Londonish
Contact:

Post by Mayhem »

My car occasionally suffers grinding on reverse... to worry yet?
Lie with passion and be forever damned...

Xbox: Mayhem64
User avatar
MadHippo
Baaaaaaa!
Baaaaaaa!
Posts: 6529
Joined: Mon Dec 09, 2002 11:29 pm 0
Yahoo Messenger: madhippo1
Location: Reading, more-or-less.

Post by MadHippo »

My car needs a service & MOT. Can't afford it at the moment though.
Damn stupid lack of decent public transport infrastructure.
XBox Live Gamertag: MadHippo1
User avatar
hairy_pete
Baaaaaaa!
Baaaaaaa!
Posts: 7217
Joined: Mon May 27, 2002 8:10 pm 0
Location: A Tiny Village in Bavaria

Post by hairy_pete »

Kelloggs wrote:(Note: This is what happens when I go to bed. Everyone wakes up while I'm asleep!)

The clutch on the last car was slipping, which I've experienced before. I could still drive it, but it was too far gone for others to.

I don't think it's my driving, but this is now the third bit of clutchwork needed in seventeen years' driving. I'm of the mind that - despite Ford's best protestations - such a major subsystem shouldn't be developing a fault quite so soon, unless I'm doing something so daft with the car as to leave evidence elsewhere.
There's the fairly common driving "style" of depressing the clutch when approaching corners, releasing again on exit when it's time to accelerate again - typically with the same (high) gear selected that you had before the corner. Now, this eats clutch like there's no tomorrow, particularly true for modern age turbo diesels or anything else that does have low-rev grunt.

Nobody admits to doing that, yet when I'm in the passenger seat, I find this astonishingly popular.
User avatar
kalmar
Baaaaaaa!
Baaaaaaa!
Posts: 8293
Joined: Fri Jun 24, 2005 2:46 pm 0
Location: Fife

Post by kalmar »

Mayhem wrote:My car occasionally suffers grinding on reverse... to worry yet?
Probably not. Reverse has no synchromesh so it'll be likely to crunch, especially if you've just stopped moving.
If you don't want it to happen, put it into 3rd first and then quickly go to reverse, that will stop the gearbox shafts spinning.
(just show, no stabby stabby)
User avatar
lis0r
Baaaa!
Baaaa!
Posts: 894
Joined: Tue Jan 10, 2006 9:26 am 0
Location: The Frozen Wastelands Of The North

Post by lis0r »

hairy_pete wrote:There's the fairly common driving "style" of depressing the clutch when approaching corners, releasing again on exit when it's time to accelerate again - typically with the same (high) gear selected that you had before the corner. Now, this eats clutch like there's no tomorrow, particularly true for modern age turbo diesels or anything else that does have low-rev grunt.
Doesn'tthis massively increase the chance of losing traction on the corner?
Post Reply