piku wrote:hairy_pete wrote:It's the aforementioned "high gear soft-engage while accelerating" technique that literally burns the pad off.
So you should smoothly and quickly lift your foot off the clutch when changing gears at speed?
Yes. The art in upshifting lies in the timing - clutch, shift, reengage exactly when the engine's falling revs match the next gear's ratio. If you get that timing perfectly right, you can even upshift without using the clutch at all - without causing any nasty noises or gearbox wear. Don't try this at home.
When downshifting, the timing trick is to rev the engine up just in the right moment with the clutch reengaging.
Up or down, you never use clutch slip to compensate for rev mismatch.
Other related mistakes and their damage: Engaging too hard from zero velocity can ruin the damper springs.
That'll be why my car goes *clunk* when setting off then... It's impossible to smoothly set off in my car, I've tried various combinations of accelerator and clutch. At first I thought it was my driving, but I can do it fine in any other car or van.
Most definitely. My Citroën DS was like that too, absolutely impossible to drive off smoothly.
Keeping the clutch depressed while halted grinds away at the clutch bearing.
I do that when at traffic lights, but when stuck in traffic jams and whatnot I stick it in neutral. It's either that or my leg goes to sleep. And I make sure I'm not riding the clutch by putting my left foot on the floor.
It's better to learn guesstimate when the lights will go green. To minimize foot-on-clutch time, put 1st gear in just a couple of seconds before that happens.
Would mis-aligned/balanced front wheels (caused by hitting the kerb at speed and once hitting a large rock in the middle of the sodding road) cause the CV joins to wear quicker than usual?
If that kind of bump damages the front suspension, your car's crap anyway

Seriously, nah, CV joints don't suffer from such slight misalignment. You need a lot more "wrong angle" for that. They do suffer from seriously wrong ride height (an exclusive Citroën phenomenon

if it weren't for the DIY lowered-suspension crowd). The #1 reason however is running them dry. Check your rubber sealbags (don't forget there's four of these!).